Horizontal Position In Welding Link

Performed on the upper side of a horizontal surface and against a vertical surface, such as a T-joint. It is often considered easier because the horizontal plate acts as a "shelf" to support the puddle.

: Occurs when the arc "eats" into the top vertical plate without filling it with metal, often due to an incorrect work angle. horizontal position in welding

Horizontal welding typically requires than flat welding. Excessive heat makes the metal too fluid, causing it to sag. Lowering the amperage allows the puddle to freeze (solidify) faster. Performed on the upper side of a horizontal

: For multi-pass welds, start at the bottom of the joint. The first bead creates a physical ledge that supports subsequent beads, preventing them from dripping down. Horizontal welding typically requires than flat welding

Marco ground out his mess and tried again. This time, he tilted the electrode 5–10 degrees upward, kept a tight arc, and moved steadily. He watched the puddle solidify like a tiny shelf, each ripple locking in place before the next. The weld was flat on top, slightly convex on the bottom face, and fully fused.